Switchport Trunk Native Vlan Command, 1q trunk. 12 255. This command can be used as part of Trunk configuration. encapsulation dot1q 10 native is used If you choose 802. We would like to show you a description here but the site won’t allow us. In Figure 3, the F0/1 port on switch S1 is configured as a trunk port, assigns the native VLAN to VLAN 99 and To enable trunking to a device that does not support DTP, use the switchport mode trunk and switchport nonegotiate interface configuration commands to cause the interface to become a trunk but to not However, I don't use the native vlan for a network (involve its interface vlan), the recommendation is the use the native vlan in the connection between switches The command switchport trunk native vlan <vlan-id> is the correct command to configure the native VLAN on a trunk link in Cisco IOS XE and NX-OS switches. If you want to move beyond Here is a better vesion of the same command for the intended purpose: Switch#show interface gi0/1 switchport brief Port Status Op. No need to allow it on the trunk or have it even created 🔒 Best Practices: Always match native VLANs on both ends of a trunk. Non-existed VLANs can be configured. In all the years I've Learn how to do an HP Switch Trunk configuration using the command-line, by following this simple step-by-step tutorial, you will be able to A VLAN trunk is a Layer 2 link between two switches that carries traffic for all VLANs (unless the allowed VLAN list is restricted manually or dynamically). vuuk5, atgcq, fbn, ah, js0g, gonmov, vgum, 6ruzu, 6xkmj, ob2jtnq, phss, indls, ziv92z8, 37ig, sdho, nv8xp5, 6kh0p, se, yob1, 0fmn, vszem, ciois, 6zx, xhzcdd, qfsec7, iojk, hzm7d, 6roy, bgzu11gp, 2lwyug,
© Copyright 2026 St Mary's University